APPLICATION: 1997, 1998, 1999, 2000, 2001, 2002 LS1/LS6 Camaro, Firebird, Trans Am, & Corvette LS1/LS6 engines (DRIVE BY CABLE ONLY) w/ 4L60E-75/4L80E automatic transmissions and 3 Pin LS1 MAF using RED/BLUE 411 P01 PCM
PARTS INCLUDED: Complete engine and transmission Harness, Instruction Manual
ADDITIONAL ITEMS REQUIRED: RED/BLUE 411 P01 PCM
CONNECTIONS FOR:
- Fuse/Relay Box
- Fuel Pump Control (Relay included)
- Fan controls (Relays and fuse available separately KIT-1010)
- Check Engine Light, Speedo output, Tachometer, OBD2 Port
- IAC and TPS on DBC setups
- MAF Sensor
- MAP Sensor
- Engine Coolant Temp Sensor
- Alternator Control
- (2) Upstream Oxygen Sensors
- Crankshaft Position
- Camshaft Position
- Fuel Injectors
- Coil Packs
- Automatic or Manual Transmission control
- Knock Sensors
|
Connections from the Harness You Will Need to Hookup:
- Fuel Pump (Required)
- Switched Ignition Power (Required)
- Malfunction Indicator (Check Engine, MIL, CEL, ETC.)
- Speedometer
- Tachometer
- Fan 1 Relay Control (Low Speed or Single Control)
- Fan 2 Relay Control (High Speed or Second Fan Control)
- Fan Relays available separately KIT-1010
|
NOTES: These Harnesses are designed for retrofitting '97 - '02 LS1/LS6 engines and 4L60E-75 transmissions into older muscle cars and street rods or newer non-emissions controlled vehicles. Harness allows use of the factory Vortec intake manifold and Multec Injectors with flex-fuel Injectors (EV6) and EV1 injectors optional. They are completely plug and play with four wire hookup (switched power, constant power and ground connections required). Harnesses are designed with a sliding grommet seal and 4 - 5 feet of length from the rear of the cylinder head to the PCM mounting position under the vehicle dashboard. A sliding grommet seal allows for professional, leak proof installation.
Harnesses are professionally constructed from Brand New GM Delphi Connectors and TXL (Polyethylene Cross Linked) High Temperature Wire to GM Specifications. All Harnesses are 100% Quality Inspected prior to shipping. All Harnesses require PCM VATs removal, available through PSI.
MADE IN THE USA
